On The Hipath 1190/1190R - Siemens HiPath 1100 Service Manual

4.7.3.3

On the HiPath 1190/1190R

Installation Procedures
Step
1. Turn off the power supply.
2. Remove the system's front cover.
3. Remove the system's back cover.
4. Move the module's latch as shown in figure 4-12.
5. Insert the module into one of the slots shown in Table 4-2.
6. Move the module's latch back to secure module.
7. Connect the Main Distribution Frame cables as follows: For modules allocated to the
system's bottom slots (slots 1 to 10) use the bottom opening (see figure 4-10). For
modules allocated to the system's top slots (slots 11 to 20) route the cables through
the top anchors (See figure 4-11).
8. Connect to the appropriate module Connectors (see "Expansion modules (EB)" on
page 3-58).
9. Attach cables to anchors using plastic brackets.
10. "Performing a visual inspection" on page 4-189.
11. Reassemble the entire set.
12. Turn on the power supply.
13. Configure the required data (see "Operation" on page 7-278).
*
14. Using Manager application go to: Advanced tab, > PBX Information tab, > Slot
Allocation tab;
Select the Clear All Slots checkbox;
Update the HiPath System;
Reset the HiPath System.
* This is necessary only if you have changed the type of the modules installed in your system.
Service Manual
Procedure
Installation
Installing modules
4-147