Fax/Did Feature - Siemens HiPath 1100 Service Manual

Mandatory - The Cost Code must be typed in at the start of the call or it cannot be
●
completed.
Cost Code confirmation (244)
When Cost Code confirmation is enabled, only Cost Codes that have been configured previously may be used (Cost Codes
must be set using HiPath 1100 Manager). If an invalid Cost Code is typed in, a negative tone will sound or a message will be
displayed.
If confirmation is disabled, any Cost Code may be used.
6.3.10

Fax/DID Feature

This provides automatic answering of an external call in addition to message playback and fax signal detection.The caller can
dial any extension or enter any digit configured in the answering menu and be transferred to another extension or group.
The feature has five modes of operation: Fax only, DID, Fax/DID, message and Auto Fax. If an S0 or TME1 module is also in-
stalled, a fourth mode of operation is available: a DID for digital lines.
Messages stored in this module can be programmed as a Second Attendant for external calls or as a Forwarding Destination
for an Extension (see Call Forwarding in the User Manual). The maximum number of simultaneous conferences supported by
the system is 8.
Call answering menu (009)
The Fax/DID lets you create a customized call answering menu transferring the call to an extension or a group, depending on
the number entered.
A call is transferred to a preconfigured destination after 3 seconds. If a digit is entered before this time has elapsed, it will be
analyzed and the call will be forwarded to a new destination. The destination can be an extension or a group.
When the Call answering menu is not configured, the system can only detect extension and group numbers.
Message recording (137)
Allows you to record and playback greetings and messages, transfers and alarms. Simply speak to record or listen to the play-
back of a message right after the end of the sequence.
To stop the recording or playback of a greeting or message, press "1" .
Call answering mode configuration (127)
The Fax/DID has five modes of operation available for the different messaging requirements.
Fax reception extension (128)
Specifies to which extension a call will be transferred when a fax signal is detected on an external line.
In "Type of Equipment Connected to an Extension - Position 003" you must specify
the extension as a fax extension before programming Code 28.
Service Manual
Configuring the system specifically for the client
Comments about the system's programming codes
6-267