Usb Interface - Siemens HiPath 1100 Service Manual

7.2.1.2

USB Interface

In this case there are two possibilities: USB Interface or USB Interface + CAPI Interface.
Figure 7-2 Possible USB Configurations
In order to perform HiPath 1100 administration using a computer and a USB interface, you
must install the proper CallBridge for Data USB drivers specific for the HiPath 1100 family. This
allows the computer to communicate with the system. This task must be complete before
installing the HiPath 1100 applications.
Install the required drivers (see Chapter 7, "HiPath 1100 USB Drivers" ) then start installing the
HiPath 1100 applications:
Procedure:
1. Insert the HiPath 1100 CD in the CD drive
If Auto-Run is not configured, go to the Windows Start menu, click Run and then select the
Browse button in the dialog box. Open the SETUP.EXE file on the CD drive.
2. In the Setup window, select the language you want to use.
Once the language has been selected, all corresponding country-specific settings will be
established.
3. A window will appear where you can select the software to be installed
Service Manual
HiPath 1100 Applications
Manager Software
Billing
CommServer
CallBridge
for Data
USB
HiPath
1100
System programming mode using a PC
Possible USB
Configurations
Transmission
Status Monitor
USB
Operation
7-283