Driver Installation; Hipath 1100 Usb Drivers; Figure 7-12 Commserver Properties - Configuration Of Isdn Connections - Siemens HiPath 1100 Service Manual

8. Following the boot sequence, configure the CommServer. Right-click the CommServer
icon on the Windows status bar and select Properties. Specify these settings:
Connection Type: ISDN connection via S
●
Phone #: telephone number to be dialed by the CommServer.
●
Your MSN: MSN of the CommServer.
●
or
Connection Type: ISDN Connection via S
●
Phone #: 800
●
Your MSN: you do not need to fill this in.
●
Figure 7-12 CommServer Properties - Configuration of ISDN connections
9. When a HiPath 1100 application is activated, the server starts automatically.
7.3

Driver Installation

7.3.1

HiPath 1100 USB Drivers

Two types of USB drivers can be installed for the HiPath 1100 system: Administration USB
driver or Administration + CAPI Interface USB driver.
If all you need is administration of the HiPath 1100 system, install the Administration USB
drivers package. If you wish to use CAPI services, in addition to performing HiPath 1100
system administration, you will need to install the Administration + CAPI Interface drivers.
Service Manual
Trunk
0
BUS
0
Operation
Driver Installation
7-295