Adsl Module - Siemens HiPath 1100 Service Manual

Do not connect the V.24 interface to the PABX when using a network interface
●
cable. All data is delivered through the network.
ADSL modem access must be enabled by a carrier for one of the PABX lines.
●
An Internet provider is also required.
Remember to configure the ADSL connection in the CommServer.
●
All the PCs must have a network card installed and be in the same network as
●
the LAN interface module.
3.6.1.1

ADSL module

This is a previous version used initially on HiPath 1100 V6.0 equipped with ADSL modem
functions and LAN interface on the same board.
The parameters required for this to work correctly must be set using the administration software
"HiPath 1100 Manager" on page 7-336.
Functions
ASDL modem with Full ADSL (8 Mbps downstream and 1 Mbps upstream - ITU G.922,1)
●
and ADSL G2.Lite (1.5 Mbps downstream and 512 kbps upstream - ITU G2.922,2, ANSI
T1.413-1998 Standard) capability.
4 10/100 Base-T standard HUB ports with four ports for building a small LAN.
●
Module with built-in microfilter to separate voice and data signals.
●
Service Manual
Modules
Optional modules (MO)
3-81