Digital Trunk Settings - Siemens HiPath 1100 Service Manual

If only one extension is selected as the first attendant, only one voice mail group
may be selected as a second MSN attendant, (See HiPath 1100 Manager).
Mailbox assignment for Auto-answering mode (216)
This setting assigns auto-answering to mailboxes.
Audio Quality (228)
This setting specifies the audio quality for playing back greetings and messages.
Message/Greeting for an external analog line (230)
This specifies whether a message/greeting should be played for an external analog line.
6.3.12

Digital trunk settings

The HiPath 1100 systems can be equipped with digital trunks by means of an S
CAS access).
TME1 module
E1 CAS access:
E1 CAS access allows the system to use Caller ID and direct dialing to extensions, reducing the number of lost calls and sim-
plifying access for the user. The HiPath 1150 can be equipped with one TME1 module (configured for up to 15 standard chan-
nels or 20 expanded channels) and the HiPath 1190 with two TME1 channels.
When only E1 digital lines are used, you only need to program the external number registration. Country Code and Area Code
can be left blank.
S2 access:
It provides connections to the ISDN network via primary access (30 Channels), allowing services offered by the network to be
used. The HiPath 1150 can be equipped with one TME1 module (configured for up to 30 channels) and the HiPath 1190 with
two TME1 modules (the first configured for up to 30 channels and the second up to 15 channels).
When the total number of digital trunks configured for the module plus the number of external analog lines exceed the maxi-
mum capacity of the system, the external analog lines for the EB 202, 206 or 210 expansion modules are disabled. Nonethe-
less, the extensions will continue to work as usual. Lines are disabled in the order that they are physically installed (1, 2, and
so on). This process continues until the total number equals the required number of trunks. The remaining modules continue
operating as usual.
However, in the case of the EB 200, 400 and 800 modules, it is strongly recommended that you change their slots to prevent
their being deactivated. The modules become inoperable if any one of their external line slots is disabled.
To determine how many analog and how many digital lines will be available on your system, see Table 2-3 on page 2-33:
S module:
0
Each ISDN access provides two communication channels (64 kbps each) as well a capability for sharing applications such as
video conferencing and Internet access. Depending on your carrier, some features may be provided, including Caller ID, Caller
ID Blocking, Direct Dialing to Extensions and so on. The HiPath 1120 can be equipped with a 2-port module, the HiPath 1150
with a 2-port module or a 5-port module and the HiPath 1190 with two 2- or 5-port modules.
Service Manual
Configuring the system specifically for the client
Comments about the system's programming codes
module (ISDN/ISDN access) and a TME1 (E1
0
6-271