Installing An Evm Module; On The Hipath 1120; Figure 4-23 Installation Module Baby Board Adsl On The Hipath1150/1190/1190R - Siemens HiPath 1100 Service Manual

Assembly Diagram
Figure 4-23 Installation module Baby Board ADSL on the HiPath1150/1190/1190R
4.7.7

Installing an EVM module

4.7.7.1

On the HiPath 1120

Installation Procedures
Step
1. Turn off the power supply.
2. Remove the system's cover
3. Attach the separator provided with the module to the MB.
4. Attach the module to the MB's pin Connector and to the separator.
5. Reassemble the entire set.
6. "Performing a visual inspection" on page 4-189.
7. Turn on the power supply.
8. Configure the required data (see "Operation" on page 7-278).
Service Manual
X14
X6
X14
X6
X7
Procedure
Installing modules
X7
Installation
4-153