Figure 7-52 Windows 2003 - Msn - Siemens HiPath 1100 Service Manual

Operation
Driver Installation
Figure 7-52 Windows 2003 - MSN
7. The installation of the USB drivers will be confirmed. Click "Finish."
8. A message will appear that HiPath 1000 drivers are being searched for. Repeat driver
installation procedures for USB interface devices (Steps 1 to 3)
9. Click "Next" to proceed.
10. A message will appear twice to the effect that the driver does not have a Windows logo.
Click "Continue" every time this message will appear.
11. The installation of the USB drivers is now complete. CAPI applications installation will now
start automatically (see "CAPI Application setup" on page 7-331).
Windows XP
You must have administrator's access privileges to install any software
Proceed as follows:
1. Connect the HiPath 1100 system to the computer
2. The Found New Hardware Wizard window will appear so that new drivers can be installed.
Choose "Install from a list or specific location (Advanced)" Click "Next" to proceed.
7-328
Service Manual