Figure 7-11 Isdn Configuration Options - Siemens HiPath 1100 Service Manual

Operation
System programming mode using a PC
HiPath 1100 Applications
Manager Software
Billing
CAPI
driver
ISDN
Card
S BUS
0
Figure 7-11 ISDN Configuration options
Procedure:
1. Check that the HiPath 1100 system is ON
2. Insert the system CD in the CD drive.
If Auto-Run is not configured, go to the Windows Start menu, click Run and then select the
Browse button in the dialog box. Open the SETUP.EXE file on the CD drive.
3. In the Setup window, select the language you want to use
4. A window will appear where you can select the software to be installed
5. Install your selected software components sequentially. For programming the HiPath 1100
system, the following applications must be installed:
HiPath 1100 Manager and
●
CommServer (installs automatically).
●
6. After each component is installed, a message is displayed indicating that the installation
was completed successfully. Click "Next" every time it appears
7. Select "Close" to close the installation window. Installation is then completed and the
computer has to be restarted.
7-294
Transmission
Status Monitor
CommServer
S
0
inte
HiPath 1100 Applications
Manager
Billing
CommServer
HiPath
1100
S
0
OR
ext
Software Transmission
Status Monitor
CAPI
driver
ISDN
Card
S
0
Trunk
NTBA
Service Manual