Siemens HiPath 1100 Service Manual page 246

Configuring the system specifically for the client
Comments about the system's programming codes
Feature limited to specific countries.
Within the system, Silent Monitoring has the same limitation as the Conference and
Override features.
A maximum of 2 simultaneous conferences is allowed by the system. Note: The
Override feature is ticketed as a Conference. If the monitoring or the monitored party
change status, silent monitoring will be canceled. This occurs, for example, when a
call is placed on hold.
Call Identification for analog extension (CLIP) (010)
When this feature is enabled and the extension receives an incoming call, the DTMF generator
will send a signal and display the callers information at the extension. When a E805C (Brazil)
or a Gigaset 4010 telephone is used, the Caller ID information is shown on the display.
If the country set (code 165) is France, the CLIP FSK feature will only be available for
the HiPath 1120 .
Hide Group Prefix (188)
This settings allows an extension to receive an external call over an external line belonging to a group of external lines, and to
hide the group number so it does not show on the display. When a special access external call is transferred to an extension
with this feature enabled, the external line number does not show on the display.
For example, an analog extension receives an external call over an external line that belongs to Group 890 - number 24987049.
When this feature is enabled, the display show only 24987049. When this feature is disabled, the display shows 89024987049,
that is, the number for the group of external lines followed by the external number.
To enable this feature, analog extensions must be configured for CLIP .
Electronic Lock Password (126)
It blocks the extension from making external calls allowing only internal calls or dialing a number directly from the Phonebook.
A 5 digit password is used to configure this setting. Should the user forget the password used to block the extension, the
password can be reset to the system's default (default password is 0000).
Timeout Call Forwarding - No Answer (130)
This setting specifies the time duration for external calls to ring at an extension before being transferred to a second attendant,
if there is no answer (*14).
Dialing Mode (168)
This setting specifies the dialing mode to be used by each extension or whether the dialing mode should be detected auto-
matically. Dialing modes are pulse (DP) and tone (MF).
6-246
Service Manual