-300 To -399, Device-Specific Errors - Keysight n9020a Service Manual

Instrument Messages
Event Messages
–300 to –399, Device-Specific Errors
Err# Message
–300
Device-specific error
–310
System error;
–310
System error; A
license will soon
expire;<feature code>
will expire in <time>
–310
System Error; enable
GPIB controller mode
–310
System error; Error
transmitting a LAN
event to the network.
–310
System error; Failed
to initialize the PTP
clock to current
time.
–310
System error; Failed
to instantiate the
PTP ordinary clock.
–310
System error; feature
<feature code> not
licensed
–310
System error; Feature
expired; <feature
code>
–310
System error; License
installation
failed;<feature code>
–310
System error; License
removal failed;
<feature code>
–310
System error; No
license; <feature
code> will terminate
in <time>
Verbose/Correction Information
An instrument error occurred and the exact problem cannot be specifically
identified. Report this error to the nearest Keysight Technologies sales or
service office
An internal system-type error has occurred. The exact problem cannot be
specifically identified. Report this error to the nearest Keysight Technologies
sales or service office
The indicated feature/software will expire in the specified time. Contact
Keysight Technologies to purchase continued use of this functionality
System, I/O Config, GPIB
Press
that the analyzer can control the source over GPIB
Communication with the network driver failed
Failure communicating with the DMC libraries' PTP controller
Failure in the starting up the DMC libraries' PTP controller
The specified feature, for example "N9073A-TR2", is not licensed. The license
may have expired. You cannot use it until you obtain a license
The specified feature has expired. The license is no longer valid
The license installation of the specified feature, for example "N9073A-TR2",
has failed. You should refer to the event log in the control panel for more details
The license removal of the specified feature, for example "N9073A-TR2" has
failed. You should refer to the event log in the control panel for more details
The specified feature will stop working in the specified time due to the license
expiration You will be prompted to save results and exit
86
and set GPIB Controller to Enabled so