Replacement - Keysight n9020a Service Manual

Assembly Replacement Procedures
Front End Control Assembly

Replacement

1. Refer to
2. Reattach the ribbon cables W16, W17, and W18 and the wire harness
W22 will not be present in instruments with Option 503.
NOTE
3. Replace the instrument top brace. Refer to the Top Brace and Reference
4. Replace the instrument outer case. Refer to the Instrument Outer
Figure 14-36. Install the Front End Control assembly into slot 6 in
the chassis securing with the ejector.
W22 to the Front End Control assembly (1). If the instrument has the
Enhanced Front End Control Assembly, reattach the additional cables as
shown in.Figure 14-37.
Bracket replacement procedure.
Casereplacement procedure.
483