Condition Errors 801 To 899, Temperature - Keysight n9020a Service Manual

Instrument Messages
Condition Messages
Err# Bit in Message
status
register
715 7 unused
717 8
Paused
719 9
Source Sweeping
721 10
DC Coupled
723 11 unused
725 12
Source Waiting for
Trigger
727 13 unused
729 14 unused

Condition Errors 801 to 899, Temperature

This series of errors corresponds to the bits in the
STATus:QUEStionable:TEMPerature register. The second column in the
table shows the corresponding bit in that register.
An event with the error number shown in the table means the condition has
been detected. When the condition is cleared, an event with the error number
plus 1000 is generated. These error numbers can be viewed in the Show Errors
screen, along with the DETECTED and CLEARED indicators.
For example, error 801 indicates that the Ref Osc Oven Cold condition has
been detected; error 1801 indicates that condition has been cleared.
This register is summarized as bit 4 of the STATus:QUEStionable register, as
described in the section
page
Err# Bit in Message
status
register
801 0
Reference Oscillator Oven
Cold
Error or
Warning
status bit
only
status bit
only
W
status bit
only
"Condition Errors 601 to 699, Error Summaries" on
133.
135
More Information
The "Source Sweeping" bit is used to indicate
various conditions, depending on the Mode of
operation:
In the List Sequencer mode, it is used to indicate
that the sequencer is running
In the EMI Receiver mode, it is used to indicate
that scan results are available from the Frequency
Scan measurement
Error or More Information
Warning
W (not currently in use)