Separate Aif/Dif Assembly - Keysight n9020a Service Manual

Assembly Replacement Procedures
Analog I.F. (AIF)/Digital I.F. (DIF) Assembly

Separate AIF/DIF Assembly

1. To separate the AIF (1) from the DIF (2), unplug ribbon cable W2 from
2. Refer to
Figure 14-64 AIF/DIF Separation
AIF/DIF Pre-installation
1. Set the DIF in position over the AIF. Reinstall the three screws removed
2. To reconnect the AIF and the DIF, reconnect the ribbon cable W2.
the AIF assembly.
Figure 14-64. From underneath the assembly, remove the three
screws (3).
before. Torque to 9 inch-pounds, starting with the middle screw.
514