Attenuators - Keysight n9020a Service Manual

Assembly Replacement Procedures
RF Area

Attenuators

Removal
1. Refer to
2. Remove the W16 ribbon cable attached to the attenuator.
3. Remove the two screws (3) or (4) for each attenuator bracket to remove
4. Remove the two screws to separate the attenuator from the bracket.
Figure 14-31 Attenuators Removal
Figure 14-31. To remove Attenuator A (1) or Attenuator B (2),
remove the semi-rigid cables W9, W10, W11 and W19 attached to the
attenuator using the 5/16 inch wrench.
from the chassis using the T-10 driver.
474