Separate Aif/Dif Assembly - Keysight N8973B Service Manual

Assembly Replacement Procedures
Analog I.F. (AIF)/Digital I.F. (DIF) Assembly

Separate AIF/DIF Assembly

1. To separate the AIF (1) from the DIF (2), unplug ribbon cable W2 from
2. Refer to
Figure 15-41 AIF/DIF Separation
AIF/DIF Pre-installation
1. Set the DIF in position over the AIF. Reinstall the three screws removed
2. To reconnect the AIF and the DIF, reconnect the ribbon cable W2.
442
the AIF assembly.
Figure 15-41. From underneath the assembly, remove the three
screws (3).
before. Torque to 9 inch-pounds, starting with the middle screw.
Keysight NFA Series Noise Figure Analyzers Service Guide