Debug Dot1X - Cisco Catalyst 2950 Command Reference Manual

debug dot1x

debug dot1x
Use the debug dot1x privileged EXEC command to enable debugging of the IEEE 802.1x authentication
feature. Use the no form of this command to disable debugging.
Syntax Description
all
errors
events
packets
registry
state-machine
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.1(6)EA2
12.1(14)EA1
Usage Guidelines
The undebug dot1x command is the same as the no debug dot1x command.
Related Commands Command
show debugging
show dot1x
Catalyst 2950 and Catalyst 2955 Switch Command Reference
C-4
debug dot1x {all | errors | events | packets | registry | state-machine}
no debug dot1x {all | errors | events | packets | registry | state-machine}
Display all IEEE 802.1x authentication debug messages.
Debug IEEE 802.1x error debug messages.
Debug IEEE 802.1x event debug messages.
Debug IEEE 802.1x packet debug messages.
Debug registry invocation debug messages.
Debug state-machine related-events debug messages.
Modification
This command was introduced.
The authsm, backend, besm, core, and reauthsm keywords were removed.
The errors, events, packets registry, and state-machine keywords were
added.
Description
Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Configuration Fundamentals
Command Reference for IOS Release 12.1 > Cisco IOS System
Management Commands > Troubleshooting Commands.
Displays IEEE 802.1x statistics, administrative status, and operational status
for the switch or for the specified interface.
Appendix C Catalyst 2950 and 2955 Switch Debug Commands
OL-10102-01