Cisco Catalyst 2950 Command Reference Manual page 367

Hide thumbs Also See for Catalyst 2950:
Table of Contents

Advertisement

Chapter 2
Catalyst 2950 and 2955 Cisco IOS Commands
PortSecure:
Dot1x:
This is an example of output from the show interfaces command for a specified interface:
Switch# show interfaces fastethernet0/1
FastEthernet0/1 is up, line protocol is down
Hardware is Fast Ethernet, address is 0005.7428.09c1 (bia 0005.7428.09c1)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed
input flow-control is off, output flow-control is off
Last input never, output 4d21h, output hang never
Last clearing of "show interface" counters never
Input queue:0/75/0/0 (size/max/drops/flushes); Total output drops:0
Queueing strategy:fifo
Output queue :0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
This is an example of output from the show interfaces description command for an interface when the
interface has been described as Connects to Marketing by using the description interface configuration
command.
Switch# show interfaces gigabitethernet0/1 description
Interface Status
Gi0/1
This is an example of output from the show interfaces pruning command for an interface when pruning
is enabled in the VTP domain:
Switch# show interfaces fastethernet0/1 pruning
Port
Fa0/1
Port
Fa0/1
This is an example of output from the show interfaces stats command:
Switch# show interfaces stats
Vlan1
Interface Vlan5 is disabled
FastEthernet0/1
0L-10102-01
Yes
Yes
reliability 255/255, txload 1/255, rxload 1/255
1 packets input, 64 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
1 packets output, 64 bytes, 0 underruns
0 output errors, 0 collisions, 2 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
Protocol Description
up
down
Vlans pruned for lack of request by neighbor
4,196
Vlan traffic requested of neighbor
1,4
Switching path
Processor
Route cache
Total
Switching path
Processor
Connects to Marketing
Pkts In
Chars In
Pkts Out
3224706
223689126
3277307
0
0
3224706
223689126
3277307
Pkts In
Chars In
Pkts Out
3286423
231672787
Catalyst 2950 and Catalyst 2955 Switch Command Reference
Chars Out
280637322
0
0
280637322
Chars Out
179501
17431060
show interfaces
2-339

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 2955

Table of Contents