Cpe Speed - Cisco Catalyst 2950 Command Reference Manual

cpe speed

cpe speed
Use the cpe speed interface configuration command to set the speed of a customer premises equipment
(CPE) port. Use the no form of this command to return to the default setting.
This command is available only on Catalyst 2950 Long-Reach Ethernet (LRE) switches.
Syntax Description auto
10
100
port port-id
Defaults
The default speed is auto.
Command Modes Interface configuration
Command History Release
12.1(11)YJ
Usage Guidelines
If you do not enter the port keyword, the speed setting is applied globally to all the CPE Ethernet ports.
If you enter the port port-id keywords, the setting is applied to the specified CPE Ethernet port and
overrides any global speed settings.
Examples
This example shows how to set a port on a CPE to 100 Mbps:
Switch# configure terminal
Switch(config)# interface longreachethernet0/2
Switch(config-if)# cpe speed 100 port 1
This example shows how to return the default speed setting on all CPE Ethernet ports that were not
configured with the cpe speed {10 | 100} port port-id command:
Switch# configure terminal
Switch(config)# interface longreachethernet0/2
Switch(config-if)# no cpe speed 100
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-74
cpe speed {{auto | 10 | 100} [port port-id]}
no cpe speed {{auto | 10 | 100} [port port-id]}
Port automatically detects whether it should run at 10 or 100 Mbps.
Port runs at 10 Mbps.
Port runs at 100 Mbps.
(Optional) ID of the CPE Ethernet port. The range is 1 to 4, depending on the
CPE device.
Modification
This command was introduced.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
OL-10102-01