Show Controllers Lre Admin - Cisco Catalyst 2950 Command Reference Manual

show controllers lre admin

show controllers lre admin
Use the show controllers lre interface-id admin privileged EXEC command to display the
administrative settings of the Long-Reach Ethernet (LRE) link for a specific switch LRE port.
This command is available only on Catalyst 2950 LRE switches.
Syntax Description
interface-id
admin
dsrate
usrate
| begin
| exclude
| include
expression
Command Modes Privileged EXEC
Command History Release
12.1(11)YJ
Usage Guidelines This command displays the profile settings of an LRE switch port, even though they might not be active
if a global profile is configured on the switch.
The upstream and downstream rates are defined by the profile on the switch LRE port. To change these
rates, assign a different profile to the switch LRE port. For information about the LRE profiles, see the
switch software configuration guide for this release.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples
This is an example of output from the show controllers lre interface-id admin dsrate and show
controllers lre interface-id admin usrate commands:
Switch# show controllers lre longreachethernet0/1 admin usrate
18.750
Switch# show controllers lre longreachethernet0/1 admin dsrate
16.667
Switch# show controllers lre longreachethernet0/2 admin usrate
12.500
Switch# show controllers lre longreachethernet0/2 admin dsrate
12.500
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-302
show controllers lre interface-id admin {dsrate | usrate}[ |{begin | exclude | include} expression]
ID of the switch LRE port.
Display the administrative settings, which might not be the same as the actual values.
Display the downstream rate (in Mbps) of the LRE link.
Display the upstream rate (in Mbps) of the LRE link.
(Optional) Display begins with the line that matches the specified expression.
(Optional) Display excludes lines that match the specified expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
0L-10102-01