Logging Lre - Cisco Catalyst 2950 Command Reference Manual

Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands

logging lre

Use the logging lre interface configuration command to specify the mode in which to log Long-Reach
Ethernet (LRE) events. Use the no form of this command to disable logging of events.
This command is available only on Catalyst 2950 LRE switches.
Syntax Description event
extended
normal
Defaults
The default is normal.
Command Modes Interface configuration
Command History Release
12.1(11)YJ
Usage Guidelines
This command is not needed for normal operation of the switch. However, it can be used as a diagnostic
tool to analyze switch activity.
The maximum number of events that can be logged on a per-port basis is 50. The log overwrites itself
when it is full.
Examples
This example shows how to set logging for events:
Switch (config)# interface longreachethernet0/1
Switch(config-if)# logging lre event
Related Commands Command
clear controllers lre log
show controllers lre log
OL-10102-01
logging lre {event | extended | normal}
no logging lre {event | extended | normal}
Log events only.
Log events and all possible parameters.
Log events and some typical parameters.
Modification
This command was introduced.
Description
Deletes the history of link, configuration, and timer events for a
specific LRE port or for all switch LRE ports.
Displays the history of link, configuration, and timer events for a
specific LRE port or all switch LRE ports.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
logging lre
2-173