Cluster Management-Vlan - Cisco Catalyst 2950 Command Reference Manual

Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands

cluster management-vlan

Use the cluster management-vlan global configuration command on the command switch to change the
management VLAN for the entire cluster. Use the no form of this command to change the
management VLAN to VLAN 1.
Syntax Description
n
Defaults
The default management VLAN is VLAN 1.
Command Modes Global configuration
Command History Release
12.0(5.2)WC(1)
Usage Guidelines Enter this command only on the command switch. This command changes the management VLAN of
the command switch and member switches. Member switches must have either a trunk connection or
connection to the new command-switch management VLAN to maintain communication with the
command switch.
This command is not written to the configuration file.
Examples
This example shows how to change the management VLAN to VLAN 5 on the entire cluster:
Switch(config)# cluster management-vlan 5
You can verify your settings by entering the show interfaces vlan vlan-id privileged EXEC command.
Related Commands Command
show interfaces
OL-10102-01
cluster management-vlan n
no cluster management-vlan
VLAN ID of the new management VLAN. The range is 1 to 4094.
Modification
This command was introduced.
Description
Displays the administrative and operational status of a switching
(nonrouting) port.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
cluster management-vlan
2-61