Show Fcs-Threshold - Cisco Catalyst 2950 Command Reference Manual

show fcs-threshold

show fcs-threshold
Use the show fcs-threshold user EXEC command to display the frame check sequence (FCS) bit error
rate settings on the switch interfaces.
Syntax Description | begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.1(12c)EA1
Usage Guidelines The Ethernet standard calls for a maximum bit error rate of 10
rate configurable range is from 10
The output displays the positive exponent; an output of 9 indicates that the bit error rate is 10
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples
This is an example of output from the show fcs-threshold command. It shows the output when all ports
are set to the default FCS threshold.
Switch# show fcs-threshold
Port
Fa0/1
Fa0/2
Fa0/3
Fa0/4
Fa0/5
Fa0/6
Fa0/7
Fa0/8
Fa0/9
<output truncated>
Related Commands Command
fcs-threshold
Catalyst 2950 and Catalyst 2955 Switch Command Reference
A-20
show fcs-threshold [ | {begin | exclude | include} expression]
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
FCS Threshold
8
8
8
8
8
8
8
8
8
Description
Sets the FCS threshold on an interface.
-6 -11
to 10 . The bit error rate input to the switch is a positive exponent.
Appendix A Catalyst 2955 Alarm Commands
-8
. In the Catalyst 2955 switch, the bit error
-9
.
OL-10102-01