Set - Cisco Catalyst 2950 Command Reference Manual

set

set
Use the set policy-map class configuration command to classify IP traffic by setting a Differentiated
Services Code Point (DSCP) value. Use the no form of this command to remove traffic classification.
This command is available only if your switch is running the enhanced software image (EI).
Syntax Description new-dscp
Defaults No traffic classification is defined.
Command Modes Policy-map class configuration
Command History Release
12.1(6)EA2
Usage Guidelines The set command can be used in a policy with a match command.
The set command sets the DSCP value for in-profile packets.
Note This command does not support IP precedence.
To return to policy-map configuration mode, use the exit command. To return to privileged EXEC mode,
use the end command.
Note For more information about configuring access control lists (ACLs), see the "Configuring Network
Security with ACLs" chapter in the software configuration guide for this release.
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-266
set ip dscp new-dscp
no set ip dscp new-dscp
Modification
This command was introduced.
Chapter 2
New DSCP value assigned to the classified traffic.
The supported DSCP values are 0, 8, 10, 16, 18, 24, 26, 32, 34, 40,
46, 48, and 56.
Catalyst 2950 and 2955 Cisco IOS Commands
0L-10102-01