Cpe Shutdown - Cisco Catalyst 2950 Command Reference Manual

cpe shutdown

cpe shutdown
Use the cpe shutdown interface configuration command to disable one or more customer premises
equipment (CPE) ports. Use the no form of this command to enable a port.
This command is available only on Catalyst 2950 Long-Reach Ethernet (LRE) switches.
Syntax Description port port-id
Defaults The CPE ports are enabled.
Command Modes Interface configuration
Command History Release
12.1(11)YJ
Usage Guidelines If the port keyword is not specified, the value is applied globally to all the CPE Ethernet ports. If the
port keyword is specified, the value is applied to the specific CPE Ethernet port and overrides any global
speed settings.
The CPE Ethernet ports can be shut down at the CPE device level and the port level. If you add a
configuration at the CPE device level and at the port level, you must enter the no form of the command
for both configurations to return the port to the default state.
Examples
This example shows how to disable all ports on the CPE device:
Switch# configure terminal
Switch(config)# interface longreachethernet0/2
Switch(config-if)# cpe shutdown
This example shows how to disable port 2 on the CPE device:
Switch# configure terminal
Switch(config)# interface longreachethernet0/2
Switch(config-if)# cpe shutdown port 2
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-72
cpe shutdown [port port-id]
no cpe shutdown [port port-id]
(Optional) CPE Ethernet port identifier. The range is 1 to 4, depending on the
CPE device.
Modification
This command was introduced.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
OL-10102-01