Cisco Catalyst 2950 Command Reference Manual page 597

Appendix A Catalyst 2955 Alarm Commands
Table A-1
Table A-1
AlarmList ID Alarm Description
1
2
3
4
After you have created an alarm profile, you can attach the profile to an interface by using the
alarm-profile interface configuration command.
By default, the defaultPort profile is applied to all interfaces. This profile enables only the Port Not
Operating (3) alarm. You can modify this profile by using the alarm profile defaultPort global
configuration command to enter alarm profile configuration mode for this profile.
Examples
This example shows how to create the alarm profile fastE for a port with the link-down (alarm 1) and
port not forwarding (alarm 2) alarms enabled. The link-down alarm is connected to the minor relay
circuitry, and the port not forwarding alarm is connected to the major relay circuitry. These alarms are
sent to an SNMP server and written to the system log file (syslog).
Switch(config)# alarm profile fastE
Switch(config-alarm-prof)# alarm 1 2
Switch(config-alarm-prof)# relay major 2
Switch(config-alarm-prof)# relay minor 1
Switch(config-alarm-prof)# notifies 1 2
Switch(config-alarm-prof)# syslog 1 2
This example shows how to delete the alarm relay profile named my-profile:
Switch(config)# no alarm profile my-profile
Related Commands Command
alarm profile (interface
configuration)
show alarm profile
snmp-server enable traps
OL-10102-01
lists the alarm IDs and their corresponding alarm descriptions.
AlarmList ID Numbers and Alarm Descriptions
Link Fault
Port not Forwarding
Port not Operating
FCS Error Rate exceeds threshold
Description
Attaches an alarm profile to an interface.
Displays all alarm profiles or a specified alarm profile and lists the
interfaces to which each profile is attached.
Enables the switch to send SNMP notification for various trap types
to the network management system (NMS).
Catalyst 2950 and Catalyst 2955 Switch Command Reference
alarm profile (global configuration)
A-7