Show Rps - Cisco Catalyst 2950 Command Reference Manual

Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands

show rps

Use the show rps privileged EXEC command to display the status of the Cisco Redundant Power System
(RPS).
Syntax Description | begin
| exclude
| include
expression
Command Modes Privileged EXEC
Command History Release
12.0(5.2)WC(1)
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show rps command.
Switch# show rps
GREEN
Table 2-28
Display
BLACK
GREEN
ALT_GREEN_BLACK
0L-10102-01
show rps [ | {begin | exclude | include} expression]
(Optional) Display begins with the line that matches the specified expression.
(Optional) Display excludes lines that match the specified expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
show rps Output Description
Description
The RPS is off or not properly connected.
The RPS is connected and ready to provide back-up power, if required.
The RPS is connected but is unavailable because it is providing power to
another device (redundancy has been allocated to a neighboring device).
Table 2-28
Catalyst 2950 and Catalyst 2955 Switch Command Reference
show rps
describes the possible output.
2-397