Cisco Catalyst 2950 Command Reference Manual page 149
Hide thumbs
Also See for Catalyst 2950:
- Configuration manual (710 pages) ,
- Software configuration manual (674 pages) ,
- Command reference manual (408 pages)
Table of Contents
Advertisement
Chapter 2
Catalyst 2950 and 2955 Cisco IOS Commands
hw-module slot
Once started, an LRE upgrade can only be stopped by physically changing the remote CPE device or by
reloading the software on the Ethernet switch.
In most cases, configuration for upgrades is not necessary.
Examples
This example shows how to start a system-wide LRE upgrade:
Switch# hw-module slot 0 upgrade lre
You are about to start an LRE upgrade on all LRE interfaces.
Users on LRE links being upgraded will experience a temporary
disruption of Ethernet connectivity.
Start LRE upgrade ? [yes]:
Starting remote upgrade on CPE Lo0/1.
Starting remote upgrade on CPE Lo0/2
Starting remote upgrade on CPE Lo0/3
Starting remote upgrade on CPE Lo0/4
Starting remote upgrade on CPE Lo0/5
Starting remote upgrade on CPE Lo0/6
Starting remote upgrade on CPE Lo0/7
Starting remote upgrade on CPE Lo0/8
Starting upgrade on local controller LongReachEthernet 0
Starting remote upgrade on CPE Lo0/9
<output truncated>
Starting remote upgrade on CPE Lo0/23
Starting remote upgrade on CPE Lo0/24
Starting upgrade on local controller LongReachEthernet 2
This example shows how to start an LRE upgrade on a single LRE controller in a switch. Specifying the
interface-id as longreachethernet 0 causes an LRE upgrade to run on controller 0 in the switch.
Switch# hw-module slot 0 upgrade lre local longreachethernet 0
You are about to start an LRE upgrade on local controller LongReachEthernet 0.
Users on LRE links being upgraded will experience a temporary
disruption of Ethernet connectivity.
Start LRE upgrade ? [yes]:
Starting Upgrade on local controller LongReachEthernet 0
This example shows how to start an LRE upgrade on a single CPE device. Specifying the interface-id as
longreachethernet 0 causes an LRE upgrade to run on the CPE device connected to the LRE port 1.
Switch# hw-module slot 0 upgrade lre remote longreachethernet0/1
You are about to start an LRE upgrade on CPE Lo0/1.
Users on LRE links being upgraded will experience a temporary
disruption of Ethernet connectivity.
Start LRE upgrade ? [yes]:
Starting remote upgrade on CPE Lo0/1
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-119
OL-10102-01
- Quick Links:
- Clear Mac Address-Table
Hide quick links:
Advertisement
Table of Contents
