Setup Express - Cisco Catalyst 2950 Command Reference Manual

Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
Examples This example shows how to enable Express Setup mode:
Switch(config)# setup express
You can verify that Express Setup mode is enabled by pressing the Mode button:
•
•
If you hold the Mode button down for a total of 10 seconds, the configuration is deleted, and the switch
Caution
reboots.
This example shows how to disable Express Setup mode:
Switch(config)# no setup express
You can verify that Express Setup mode is disabled by pressing the Mode button. The mode LEDs only
turn solid green or begin blinking green if Express Setup mode is enabled on the switch.
Related Commands Command
show setup express
0L-10102-01
On an unconfigured switch, the mode LEDs begin blinking green after 2 seconds.
On a configured switch, the mode LEDs turn solid green after a total of 10 seconds.
Description
Displays if Express Setup mode is active on the switch.
Catalyst 2950 and Catalyst 2955 Switch Command Reference

setup express

2-269