Cpe Type - Cisco Catalyst 2950 Command Reference Manual

cpe type

cpe type
Use the cpe type interface configuration command to set the type of customer premises equipment (CPE)
port that is connected to a Long-Reach Ethernet (LRE) switch.
This command is available only on Catalyst 2950 LRE switches.
Syntax Description
cisco575-lre
cisco576-lre997
cisco585-lre
unknown
Defaults
The default CPE type is unknown.
Command Modes
Interface configuration
Command History Release
12.1(11)YJ
12.1(11)YJ4
Usage Guidelines
This command can only be used when the port is shut down. If the link is active on a CPE device port,
the switch detects the CPE device type and automatically modifies the configuration. You cannot change
the CPE device type on active links. For example, if the active CPE device type is cisco575-lre, you
cannot change the type to cisco585-lre or unknown.
Examples
This example shows how to set the CPE device type to cisco585-lre while the link is down:
Switch# configure terminal
Switch(config)# interface longreachethernet0/2
Switch(config-if)# cpe type cisco585-lre
Related Commands Command
show interfaces
Catalyst 2950 and Catalyst 2955 Switch Command Reference
2-78
cpe type [cisco575-lre | cisco576-lre997 | cisco585-lre | unknown]
Model number of the Cisco 575 LRE CPE device.
Model number of the Cisco 576 LRE 997 CPE device.
Model number of the Cisco 585 LRE CPE device.
An unknown CPE.
Modification
This command was introduced.
The cisco576-lre997 keyword was added.
Description
cpe Displays connection, speed, and duplex settings for CPE Ethernet ports
attached to the specified LRE switch port.
Chapter 2 Catalyst 2950 and 2955 Cisco IOS Commands
OL-10102-01