Debug Dot1X - Cisco Catalyst 3560-X Command Reference Manual

debug dot1x

debug dot1x
Syntax Description
Note
Command Default
Command Modes
Command History
Usage Guidelines
Related Commands
Catalyst 3750-X and 3560-X Switch Command Reference
B-10
Downloaded from www.Manualslib.com
Use the debug dot1x privileged EXEC command to enable debugging of the IEEE 802.1x authentication
feature. Use the no form of this command to disable debugging.
debug dot1x {all | errors | events | feature | packets | registry | state-machine}
no debug dot1x {all | errors | events | feature | packets | registry | state-machine}
all Display all IEEE 802.1x authentication debug messages.
errors Display IEEE 802.1x error debug messages.
events Display IEEE 802.1x event debug messages.
feature Display IEEE 802.1x feature debug messages.
packets Display IEEE 802.1x packet debug messages.
registry Display IEEE 802.1x registry invocation debug messages.
state-machine Display state-machine related-events debug messages.
Though visible in the command-line help strings, the redundancy keyword is not supported.
Debugging is disabled.
Privileged EXEC
Release Modification
12.2(53)SE2 This command was introduced.
The undebug dot1x command is the same as the no debug dot1x command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show dot1x Displays IEEE 802.1xstatistics, administrative status, and operational status
for the switch or for the specified port.
manuals search engine
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02