Engine Reassembly; Crankshaft - Suzuki drz 400E Service Manual

ENGINE REASSEMBLY

Reassemble the engine in the reverse order of disassembly.
Pay special attention to the following points:
NOTE:
Apply engine oil to each running and sliding part before reas-
sembling the engine.

CRANKSHAFT

1 Bearing
2 Crankshaft (R)
3 Conrod
4 Bearing
5 Crank pin
6 Crankshaft (L)
7 Bearing
Determine the width between the webs referring to the fig-
ure when rebuilding the crankshaft.
Crank-web-to-web-width
Standard: 62.0 ± 0.1 mm (2.441 ± 0.004 in)
When mounting the crankshaft in the crankcase, it is neces-
sary to pull its left end into the crankcase by using the special
tools.
09910-32812: Crankshaft installer
09940-52861: Attachment
Never fit the crankshaft into the crankcase by striking
it with a plastic hammer.
Always use the special tool, otherwise the accuracy of
the crankshaft alignment will be affected.
ENGINE 3-47