Suzuki drz 400E Service Manual page 173

6-42 CHASSIS
SWINGARM
Inspect the swingarm for damage. If any damages are found,
replace the swingarm with a new one.
CUSHION LEVER NEEDLE BEARINGS
Insert the spacers into the needle bearings, move the spacer up
and down and check for any play. If there is excessive play, re-
place the bearings with new ones.
Remove the cushion lever needle bearings using the special
tools.
09923-73210: Bearing remover
09930-30102: Sliding hammer
Replace the removed needle bearings with new ones.
CUSHION LEVER AND CUSHION LEVER RODS
Inspect the cushion lever and cushion lever rods for damage. If
any damages are found, replace the cushion lever and cushion
lever rods with new ones.
PIVOT SHAFT
Measure the pivot shaft runout using the dial gauge. If the runout
exceeds the service limit, replace the pivot shaft.
09900-20606: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
Swingarm pivot shaft runout
Service Limit: 0.3 mm (0.01 in)