Remounting - Suzuki drz 400E Service Manual

THROTTLE POSITION SENSOR INSTALLATION
Install the throttle position sensor as described below.
Measure the resistance Ω
sor terminals as shown in the illustration.
Throttle position sensor resistance Ω
Measure the resistance Ω
sor terminals as shown in the illustration.
Fully open the throttle valve with the throttle lever.
Position the throttle position sensor until resistance Ω
– 4.63 kΩ.
When the resistance Ω
throttle position sensor mounting screws.
Throttle position sensor resistance Ω
Install the air valve assembly.
First tighten the bolt 3 and then tighten the nut 4.
(DR-Z400)
Keep the clearance A (0.5 – 0.7 mm) between rink arm and
carburetor body when pushing the throttle lever as shown.
A: Clearance 0.5 – 0.7 mm
If the clearance is out of specification, adjust the clearance.

REMOUNTING

Remount the carburetor assembly in the reverse order of re-
moval. After the carburetor assembly has been remounted onto
the engine perform the following adjustments:
Throttle cable play ..................................................
Engine idle speed ..................................................
between the throttle position sen-
1
:
1
Approximately 5 kΩ Ω Ω Ω Ω
between the throttle position sen-
2
is within specification, tighten the
2
:
2
3.09 – 4.63 kΩ Ω Ω Ω Ω
FUEL AND LUBRICATION SYSTEM
Bl
B
is 3.09
2
3
2-13
2-14
4-15
Y
Ω Ω
2 1
4