Balancer Shaft - Suzuki drz 400E Service Manual

BALANCER SHAFT

1 Washer
2 Balancer driven gear
3 Bearing
4 Pin
5 Balancer shaft
6 Bearing
A Balancer shaft nut
ITEM N·m kgf-m
A
50
When installing the balancer drive gear, align the pin 1 with
the groove 2.
When installing the balancer driven gear, align the pin 3
with the groove 4.
Install the balancer driven gear by aligning the matching
marks.
Hold the generator rotor using the special tool (DR-Z400) or
a 26-mm offset wrench (DR-Z400E), and then tighten the
balancer shaft nut to the specified torque.
09930-44913: Rotor holder
Balancer shaft nut: 50 N·m (5.0 kgf-m, 36.0 lb-ft)
lb-ft
5.0 36.0
ENGINE
1
2
3
4
3-51