Suzuki drz 400E Service Manual page 138

Remove the wheel bearings as follows:
Remove the wheel hub dust seal. (
Insert the bearing remover attachment 1 into the wheel bear-
ing.
Insert the wedge bar 2 from the opposite side and lock it into
the slit of the bearing remover attachment.
Drive out the wheel bearing by striking the wedge bar.
09941-50111: Bearing remover
Replace the removed bearings with new ones.
FRONT WHEEL
Make sure that the wheel runout (axial and radial) does not ex-
ceed the service limit when checked as shown. An excessive
amount of runout is usually due to worn or loose wheel bearings
and can be corrected by replacing the bearings. If bearing re-
placement fails to reduce the runout, replace the wheel with a
new one.
Wheel rim runout (axial and radial)
Service Limit: 2.0 mm (0.08 in)
FRONT AXLE
Measure the front axle runout using the dial gauge. If the runout
exceeds the service limit, replace the front axle with a new one.
09900-20606: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block set (100 mm)
Wheel axle runout
Service Limit: 0.25 mm (0.010 in)
TIRE ..............................................................
SPOKE NIPPLES ......................................................
6-6)
2-21 and 2-22
2-22
CHASSIS 6-7
2
1