Table of Contents
Advertisement
Section 700 - Operation
Considerations
•
If several calls arrive at a DSS/BLF key, the calls are queued and ring on a first-in, first-out basis.
•
If a BLF key has a second call while busy and off- hook signaling is enabled, the BLF key starts
blinking. The call can be answered by pressing the BLF key or going on hook and then off hook.
Direct Line Appearances
CPC-96, CPC-288, and CPC-576 All Versions
Direct Line (DL) keys are used to originate and receive calls over specific trunk numbers (DL keys
can be assigned to any trunk number).
The LED for a DL key will flash red on an incoming call even if the CO line is set to ring. If another
extension answers the call, the LED on the telephone will light solid red.
Operation
To originate a trunk call...
To place a call on Exclusive Trunk Hold (page 133)...
To place a call on System Trunk Hold (page 133)...
To transfer a call...
Hardware Requirements
•
N/A
Related Programming
•
FF4: Key Assignment
Considerations
•
N/A
Multi-CO (MCO) Appearances
CPC-96, CPC-288, and CPC-576 All Versions
Description
You can make and receive CO line calls using a Multi-CO (MCO) key. Each extension can have up to
5 MCO keys.
An MCO key can be assigned to any of the pooled trunk groups. Pressing the MCO key is the same as
dialing the MCO Access Code (usually 9, 81-84).
576-13-700
Operation
DBS 576 (USA), Revised 6/11/98
Chapter 5. Key Telephone Features
Action
1. Press an idle DL key.
2. The key blinks green as the call is made.
1. Press the DL key.
1. Press the HOLD key.
1. Press the HOLD key.
2. Dial the destination extension.
3. Press the PROG key.
165
Advertisement
Table of Contents
