Dil (Direct In Line) - Panasonic KX-TDA50 Feature Manual

If the DID number is "123-4567":
1.
The PBX looks for the DID number in the table and finds it in location 1.
2.
The PBX checks the time mode.
In day mode: Calling Line Identification (CLI) distribution is enabled. The call is routed to its CLI destination,
if assigned. If not assigned, the call is routed to the DID destination, extension 105, and "Sales" is displayed.
In lunch mode: CLI distribution is disabled. The call is routed to the DID destination, extension 100, and
"Sales" is displayed.
Note
Tenant numbers and VM trunk group numbers (not shown here) can also be programmed in the DID
Table.
The tenant number programmed here is used only to determine the Time Table used by each DID number;
selecting tenant 3 means the DID number will use Time Table 3, for example. The VM trunk group number
set here is used to determine the Incoming Call Service and greeting message used by the Voice
Processing System (VPS) during the current time mode. (® 19.1.4 Voice Mail DPT (Digital) Integration)
Conditions
•
To use this feature, DID must be assigned as the distribution method for the desired CO line port.
PC Programming Manual References
4.4 [2-3] Timers & Counters—Miscellaneous—
12.2 [10-2] DIL Table & Port Settings—DID/TIE
→ Distribution Method
→ DID/TIE—Remove Digit
→ DID/TIE—Additional Dial
12.3 [10-3] DID Table
PT Programming Manual References
[451] DID Number
[452] DID Name
[453] DID Destination
Feature Manual References
3.1.12 CLI (Calling Line Identification) Distribution
9.1.10 INCOMING CALL FEATURES
17.1.3 Tenant Service
17.1.5 Time Service
21.1 Capacity of System Resources
21.2 Exclusive Features Table

4.1.6 DIL (Direct In Line)

Description
Directs an incoming public CO line call to a preprogrammed destination based on the CO line carrying the call.
Each CO line has a destination for each time mode.
Document Version 2010-11
Incoming Call Inter-digit Timer—DID
4.1.6 DIL (Direct In Line)
Feature Manual 75