Panasonic 524X07801B Technical Manual page 64

Chapter 3. System Features
Priority
4th
Lowest
For example, an outgoing call is an ARS Outgoing call (G) but it is also a transferred call. The SMDR
data condition code will be T to indicate that the call was an Outgoing Transfer. (A transferred call's
condition code takes precedence over the type of call - ARS Outgoing call [G].)
Table 8. Priority of incoming call condition codes
Priority
Highest
2nd
Lowest
For example, an incoming call is a DID.DDI Incoming call (D), but it is also a transferred call. The
SMDR data condition code will be t to indicate that the call was an Incoming Transfer call. (A
transferred call's condition code takes precedence over the type of call - DID.DDI Incoming call [D].)
Figure 1. Output data format

 
       



 
        



 
H


Condition Code: (I: Incoming call / D: DID.DDI incoming call / h: Hold incoming call / N:
1
Network incoming call / S:DISA incoming call / t: Transfer incoming call /
O: Outgoing call [Non LCR] / F: Call forward outside call / G: ARS outgoing call / H: Hold
outgoing call / L: LCR outgoing call / s: DISA outgoing call / T: Transfer outgoing call / W:
Network outgoing call)
2 Call start time (MM=01 to 12 / DD=01 to 31 / HH=00 to 23 / MM=00 to 59 / SS=00 to 59)
3 Call duration time (HH=00 to 23 / MM=00 to 59 / SS=00 to 59)
CO user No. (extension line No.: 0 to 9999 / CO line No.: C1 to C576)
4
64
Condition
Code
L L = LCR Outgoing Call
O O = Outgoing Call
Condition
Code
h or t h = Incoming Hold
t = Incoming Transfer
D, N, or S D = DID.DDI Incoming Call
N = Network Incoming Call
S = DISA Incoming Call
I I = Incoming Call
  
  
DBS 576 (USA), Revised 6/11/98
Description
Description
 

Section 700 - Operation
H


576-13-700