Table of Contents
Advertisement
Section 700 - Operation
Note:
Once in a data entry level, you must either enter an acceptable value or restore the previous
value before proceeding. For instance, if you change an entry to an unacceptable value and then press
FF1 to move to the PSD Assignment menu, you will not be able to proceed. You must first enter an
acceptable value.
Operation
To enter User Maintenance mode:
1. At a telephone with a COS that allows user login, press the
ON/OFF key.
2. Press the PROG key.
3. Press the * key twice (* *).
4. Press the CONF key.
Note:
Your extension's Class of Service must be properly set to allow User Maintenance access.
Also, only one user may enter User Maintenance or System Programming at a time.
Set System Date/Time/Day
Description
The System allows you to change the date, time, and day of week. When setting the time, you can
specify 12 or 24 hour format.
Operation
To change the system date, time, and day of week:
1. If not already in User Maintenance mode, enter User Main-
tenance mode. (See "To enter User Maintenance mode:" on
page 75.)
2. At the 81 level, enter 000.
3. Press the HOLD key.
4. Enter the year (two characters), month (two characters), and
day (two characters).
Note: To clear an entry or existing data, press the FLASH
key.
5. Press the HOLD key.
576-13-700
Action
Action
DBS 576 (USA), Revised 6/11/98
Chapter 4. User Maintenance
Result
81-
User MAINT displays
Result
81-
User MAINT displays
0
:YYMMDD
Date displays
1
:HHMM
Time displays
75
Advertisement
Table of Contents
