Table of Contents
Advertisement
Chapter 6. DSLT Features
Direct Trunk Access
Extensions can seize a specific trunk for outgoing calls. Extensions can also use Direct Trunk Access
to test trunks or to access data trunks.
Operation
To use Direct Trunk Access:
1. Lift the handset or press the ON/OFF key.
2. Enter the Direct Trunk Access code (default = 88).
3. Enter the desired trunk number.
4. Dial the phone number.
Hardware Requirements
•
N/A
Related Programming
•
FF1-0-03: Extension COS (Direct Trunk Access)
•
FF3: Extension COS
Considerations
•
N/A
MCO Trunk Access
The System supports up to 5 MCO groups for each MCO tenant group. You can seize an idle trunk
from the MCO trunk group by entering the MCO access code.
Operation
To seize an idle trunk:
1. Lift the handset or press the ON/OFF key.
2. Enter the desired trunk access number (9 or 81-84). (See
Table 15.)
3. Dial the phone number.
Hardware Requirements
•
N/A
Related Programming
•
FF1: MCO Access
244
Action
Action
DBS 576 (USA), Revised 6/11/98
Section 700 - Operation
Result
Outside dial tone
Result
Intercom dial tone
Outside dial tone
576-13-700
Advertisement
Table of Contents
