Table of Contents
Advertisement
Chapter 5. Key Telephone Features
3. Enter the OHVA feature access code (default = 8).
4. Make your announcement
To answer an OHVA:
1. Press the OHVA Split key.
Note: You must program an FF key as a split key (default =
*71) to use this feature.
2. To return to the previous call, press the Split key again.
To transfer a call using OHVA:
1. Press the HOLD key to put the current call on hold.
2. Dial the extension number to which the call is being trans-
ferred.
3. Enter OHVA feature access code (default = 8) and announce
the call to be transferred.
4. If transfer is:
• Not accepted, retrieve the call by pressing the associ-
ated flashing MCO key (if an appearing call) or by
pressing the HOLD key (if a non appearing call).
• Accepted, and On-hook Transfer is enabled for your
extension, replace the handset or press the ON/OFF
key.
If On-hook Transfer is not enabled for your extension,
press the PROG key (or RELEASE key if using DSS/
72).
172
Action
Action
Action
DBS 576 (USA), Revised 6/11/98
Section 700 - Operation
Result
• OHVA EXT XXX displays if busy
extension called (where XXX = calling
extension.
• EXT LED flashes
Result
Split key flashes red
The OHVA originating party receives
Busy signal.
Result
Current call on hold
Busy signal
576-13-700
Advertisement
Table of Contents
