Table of Contents
Advertisement
Section 700 - Operation
Operation
To establish an eight-party conference call from the idle status:
1. Lift the handset or press the ON/OFF key.
2. Enter the Eight-Party Conference code (default = 788).
3. Press the HOLD key.
4. Enter a trunk access code, or dial the number of the exten-
sion you wish to add to the call.
5. If you entered a trunk access code in step 4, dial the number
of the party you wish to add to the call. Otherwise, proceed
to step 6.
6. Press the CONF key when your call is answered.
7. To add additional parties to the call, repeat steps 3-6.
To establish an eight-party conference call from your current call:
1. While on a call, press the HOLD key.
2. Enter the Eight-Party Conference code (default = 788).
3. Enter a trunk access code, or dial the number of the exten-
sion you wish to add to the call.
4. If you entered a trunk access code in step 3, dial the number
of the party you wish to add to the call.
5. Press the CONF key when your call is answered.
6. To add additional parties to the call, press the HOLD key
and repeat steps 3-5.
Hardware Requirements
•
N/A
Related Programming
•
FF1-0-03: Extension COS (8-Party Conference)
•
FF3: Extension COS
Considerations
•
A Conference Card (VB-44120) must be installed in the System in order to use Eight-party
Conferencing.
•
If the originating party hangs up, the conference call will be disconnected. If any other party
hangs up, the conference call will remain in progress.
576-13-700
Action
Action
DBS 576 (USA), Revised 6/11/98
Chapter 6. DSLT Features
Result
Intercom dial tone
Connected to called party
Result
Current call on hold
227
Advertisement
Table of Contents
