Interface Range Name - HP 5900 series Command Reference Manual

<Sysname> system-view
[Sysname] interface range ten-gigabitethernet 1/0/1 to ten-gigabitethernet 1/0/24
vlan-interface 2
[Sysname-if-range] shutdown

interface range name

Use interface range name name interface interface-list to create an interface range, configure a name
for the interface range, and enter the interface range view.
Use interface range name name without the interface keyword to enter the view of an interface range
with the specified name.
Use undo interface range name to delete the interface range with the specified name.
Syntax
interface range name name [ interface interface-list ]
undo interface range name name
Views
System view
Predefined user roles
network-admin
Parameters
name: Specifies an interface range name, a case-sensitive string of 1 to 32 characters.
interface-list: Specifies an interface list in the format of interface-list = { interface-type interface-number
[ to interface-type interface-number ] }&<1-5>. The interface-type interface-number argument specifies
an interface by its type and number. &<1-5> indicates that you can specify up to five interfaces or
interface lists. When you specify the to keyword in interface-type interface-number1 to interface-type
interface-number2, the interfaces before and after the to keyword must be on the same interface card or
subcard. The last-tier value of the interface number before to must not be greater than the one after to,
and the values of the other tiers of the interface number before to must be the same as the one after to.
Usage guidelines
You can use this command to assign a name to an interface range and can specify this name rather than
the interface range to enter the interface range view.
In interface range view, only the commands supported by the first interface are available. The first
interface is specified with the interface range command. To view the commands supported by the first
interface in the interface range, enter the interface range view and enter a question mark (?) at the
command line interface prompt.
Failure of applying a command on one member interface does not affect the application of the command
on the other member interfaces. If applying a command on one member interface fails, the system
displays an error message and continues with the next member interface.
To verify the configuration of the first interface in the interface range, execute the display this command
in interface range view.
To view the member interfaces of an interface range, use the display current-configuration | include
"interface range" command.
To bulk configure interfaces, follow these guidelines:
46