Stp Region-Configuration - HP 5900 series Command Reference Manual

Use undo stp priority to restore the default priority.
Syntax
stp [ instance instance-list ] priority priority
undo stp [ instance instance-list ] priority
Default
The device priority is 32768.
Views
System view
Predefined user roles
network-admin
Parameters
instance instance-list: Sets the priority of the device in the MSTIs that are specified by an instance list, in
the format of instance-list = { instance-id [ to instance-id ] }&<1- 1 0>, where &<1- 1 0> indicates that you
can specify up to 10 instances or instance ranges. The instance-id argument ranges from 0 to 4094, and
the value 0 represents the CIST.
priority: Specifies the device priority in the range of 0 to 61440 in increments of 4096 (as in 0, 4096,
8192). You can set up to 16 priority values on the device. The smaller the value, the higher the device
priority.
Examples
# In MSTP mode, set the device priority to 4096 in MSTI 1.
<Sysname> system-view
[Sysname] stp instance 1 priority 4096

stp region-configuration

Use stp region-configuration to enter MST region view.
Use undo stp region-configuration to restore the default MST region configurations.
Syntax
stp region-configuration
undo stp region-configuration
Default
The default settings for the MST region are as follows:
The MST region name of the device is the MAC address of the device.
•
All VLANs are mapped to the CIST.
•
The MSTP revision level is 0.
•
Views
System view
Predefined user roles
network-admin
125