HP 5900 series Command Reference Manual page 188

Usage guidelines
If no port is specified, this command displays the global LLDP status and the LLDP status information of all
ports.
Examples
# Display the global LLDP status and the LLDP status information of all ports.
<Sysname> display lldp status
Global status of LLDP: Enable
The current number of LLDP neighbors: 0
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days, 0 hours, 4 minutes, 40 seconds
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
LLDP status information of Port 1 [Ten-GigabitEthernet1/0/1]:
Port status of LLDP
Admin status
Trap flag
MED trap flag
Polling interval
Number of LLDP neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV : 0
Table 40 Command output
Field
Global status of LLDP
LLDP neighbor information last
changed time
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1
Port status of LLDP
: 30s
: 4
: 2s
: 2s
: 5s
: 3
: Enable
: Tx_Rx
: No
: No
: 0s
: 0
: 0
: 0
: 23
Description
Indicates whether LLDP is globally enabled.
Time when the neighbor information was last updated.
LLDPDU transmit interval.
TTL multiplier.
LLDP re-initialization delay.
LLDPDU transmit delay.
Trap transmit interval.
Number of LLDPDUs sent each time fast LLDPDU transmission is
triggered.
LLDP status of port 1.
Indicates whether LLDP is enabled on the port.
181