Stp Edged-Port - HP 5900 series Command Reference Manual

Examples
# In MSTP mode, set the path cost of port Ten-GigabitEthernet 1/0/3 in MSTI 2 to 200.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/3
[Sysname-Ten-GigabitEthernet1/0/3] stp instance 2 cost 200
Related commands
display stp
•
stp pathcost-standard
•

stp edged-port

Use stp edged-port to configure the ports as edge ports.
Use undo stp edged-port to configure the ports as non-edge ports.
Syntax
stp edged-port
undo stp edged-port
Default
All ports are non-edge ports.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Usage guidelines
If a port directly connects to a user terminal rather than to another device or a shared LAN segment, this
port is regarded as an edge port. When the network topology changes, an edge port does not cause a
temporary loop. You can enable the port to transition to the forwarding state rapidly by configuring it as
an edge port. HP recommends that you configure ports that directly connect to user terminals as edge
ports.
Typically, configuration BPDUs from other devices cannot reach an edge port, because the edge port
does not connect to any other device. If a port receives a configuration BPDU when the BPDU guard
function is disabled, the port functions as a non-edge port, even if you configure it as an edge port.
On a port, the loop guard function, the root guard function, and the edge port setting are mutually
exclusive, and the one that is configured first takes effect.
When the setting is configured in Ethernet interface view, it takes effect on only that interface.
When the setting is configured in aggregate interface view, it takes effect on only the aggregate
interface.
When the setting is configured on a member port in an aggregation group, it takes effect only after the
port leaves the aggregation group.
Examples
# Configure Ten-GigabitEthernet 1/0/1 as an edge port.
<Sysname> system-view
114