Download Print this page

HP 5900 series Command Reference Manual Page 54

Layer 2 - lan switching.
Hide thumbs

Advertisement

Do not assign an aggregate interface and any of its member interfaces to an interface range at the
same time. Some commands, after being executed on both an aggregate interface and its member
interfaces, can break up the aggregation.
No limit is set on the maximum number of interfaces in an interface range. The more interfaces in
an interface range, the longer the command execution time.
The maximum number of interface range names is only limited by the system resources. To
guarantee bulk interface configuration performance, HP recommends configuring fewer than 1000
interface range names.
Examples
# Add Ten-GigabitEthernet 1/0/1 through Ten-GigabitEthernet 1/0/12 to interface range named
myEthPort, and enter the interface range view.
<Sysname> system-view
[Sysname] interface range name myEthPort interface ten-gigabitethernet 1/0/1 to
ten-gigabitethernet 1/0/12
[Sysname-if-range-myEthPort]
# Enter the view of interface range named myEthPort.
<Sysname> system-view
[Sysname] interface range name myEthPort
[Sysname-if-range-myEthPort]
47

Advertisement

Chapters

This manual also for:

5920 series

Comments to this Manuals

Symbols: 0
Latest comments: