Check Region-Configuration - HP 5900 series Command Reference Manual

undo bpdu-drop any
Default
BPDU drop is disabled on a port.
Views
Ethernet interface view
Predefined user roles
network-admin
Examples
# Enable BPDU drop on port Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] bpdu-drop any

check region-configuration

Use check region-configuration to display MST region pre-configuration information, including the
region name, revision level, and VLAN-to-instance mapping settings.
Syntax
check region-configuration
Views
MST region view
Predefined user roles
network-admin
Usage guidelines
Two or more spanning tree devices belong to the same MST region only if they are configured with the
same format selector (0 by default and not configurable), MST region name, and MST region revision
level; have the same VLAN-to-instance mapping entries in the MST region; and are connected through
a physical link.
HP recommends that you use this command to determine whether the MST region configurations to be
activated are correct. Activate them only when they are correct.
Examples
# Display MST region pre-configurations.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] check region-configuration
Admin Configuration
Format selector
Region name
Revision level
Configuration digest : 0x3ab68794d602fdf43b21c0b37ac3bca8
Instance
0
: 0
: 001122334400
: 0
VLANs Mapped
1, 3 to 4094
93