Link-Delay - HP 5900 series Command Reference Manual

Default
The device allows jumbo frames within 10000 bytes to pass through.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
value: Sets the maximum length of Ethernet frames that are allowed to pass through. The value range for
this argument is 1536 to 10000 bytes.
Usage guidelines
If you set the value argument multiple times, the most recent configuration takes effect.
Examples
# Enable jumbo frames to pass through Ten-GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] jumboframe enable

link-delay

Use link-delay to set the physical state change suppression interval on an Ethernet interface.
Use undo link-delay to restore the default.
Syntax
link-delay delay-time [ mode { up | updown } ]
undo link-delay
Default
Each time the physical link of an interface goes up or comes down, the interface immediately reports the
change to the CPU.
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
delay-time: Sets the physical state change suppression interval (in seconds) on the Ethernet interface. The
value range for this argument is 0 to 30. A value of 0 indicates that physical state changes are not
suppressed.
mode up: Suppresses the link-up events.
mode updown: Suppresses both the link-up and link-down events.
Usage guidelines
With the link-delay delay-time command configured:
20